Very happy with what l payed for it great value for money.Pictures in advertisement are old version the new unit has extra features not mentioned.Eg ethernet connection, laser cut off protection for lid open, connector for roller unit. Bed adjustment height uses motor not manual knobSize of unit is the measurement of the laser box hanging out the side not the whole unit for the 80w version. Needed a few adjustments on mirrors but expected that from shipment. Wiring all good.

Received one week after ordering. Very good packaging. All required parts included. No surprises, more or less exactly what I expected. I have only performed basic setup, no mirror alignment, and it cuts paper and cardboard easily. I haven't tried anything thicker yet, lacking proper cooling. Came with a Ruida RDC6442S-B (EC) controller. Trivial to configure with Lightburn.There was one poor-quality wire join inside the electronics enclosure. Just twisted together with electrical tape insulation, which had unwound. I have soldered and heat-shinked this join. There were a few other minor electrical termination issues, like spade connectors crimped onto insulation rather than conductor, and some terminations to a relay block using bare copper into the screw terminal ... MoreReceived one week after ordering. Very good packaging. All required parts included. No surprises, more or less exactly what I expected. I have only performed basic setup, no mirror alignment, and it cuts paper and cardboard easily. I haven't tried anything thicker yet, lacking proper cooling. Came with a Ruida RDC6442S-B (EC) controller. Trivial to configure with Lightburn.There was one poor-quality wire join inside the electronics enclosure. Just twisted together with electrical tape insulation, which had unwound. I have soldered and heat-shinked this join. There were a few other minor electrical termination issues, like spade connectors crimped onto insulation rather than conductor, and some terminations to a relay block using bare copper into the screw terminal and electrical tape insulation rather than an FC crimp, but these are the exception. Most of the terminations were with bootlace crimps and are well done.I would recommend this to anyone in the market for an 80W CO2 laser cutter in Australia.

I've had this machine for about 1 month, built quality is good and performs good, It's a good machine at a good price, very well packaged for good protection. Delivery within a week or so, I would recommend this machine, I added a water chiller, to help keep things cool in the summer months.